Wiring Instructions - Travis Industries 864 HH Installation Manual

62 Optional Equipment

Wiring Instructions

Warning: All wiring should be done by a qualified electrician and shall be in compliance with local
codes and with the current National Electric Code ANSI/NFPA 70.
Warning: Make sure the fireplace electrical circuit is disabled prior to working on electrical hookup.
Wiring Diagram - 864 HH*, 44 DV XXL, & 36 DV
* SN 3407-001010 or greater.
Fireplace
Hot
(black) (black)
Common Common
(white) (white)
Ground Ground
(green) (green)
Power Heat Duct Wiring Diagram
• 864 TRV
• 864 ST
• 864 HH
(sn 3407-001009 or less)
1 Follow the directions below to wire the blower box.
a
Attach the hot (black) and common (white) wires to the
c
leads coming from the wires (use wire nuts).
© Travis Industries
Blower
Snap Disk
Hot
Molex
Connector
Fireplace
Fireplace
Blower
Rheostat
Remove the cover from
the blower box.
Phillips
Screwdriver
(for qualified installers only)
Hot Hot
(black) (black)
Molex
Common Common
Connector
(white) (white)
Ground Ground
(green) (green)
Hot
(black)
Common
(white)
Ground
(green)
Rheostat
Junction Box
Hot Hot
(black) (black)
Common Common
(white) (white)
Ground Ground
(green) (green)
b
Insert sheathed cable through the cable clamp.
After the wires have been connected tighten the
clamp to secure the cable.
Secure the ground wire to the ground stud inside the
d
blower box by tightening the included nut over the
ground wire. Re-attach the cover removed in step
"a".
4080214
Heat Duct
Rheostat
Hot Hot
(black) (black)
Common Common
(white) (white)
Ground Ground
(green) (green)
Rheostat
Junction
Blower
Box
Junction
Box
Optional Second Heat
Duct (same rheostat and
blower wiring as above)
Blower
Assembly
Standard
Screwdriver
Ground Wire
100-01182_003
Heat Duct
Blower
Grounded
to Blower