Using The Studiolive As An Audio Interface; Using The Studiolive With Popular Audio Applications - PRESONUS StudioLive 16.4.2 Owner's Manual

6 Connecting to a Computer
6.4

Using the StudioLive as an Audio Interface

6.4 Using the StudioLive as an Audio Interface
6.4.1

Using the StudioLive with Popular Audio Applications

Apple Logic Pro/Express 7+:
Steinberg Cubase 4+
Cakewalk Sonar 6+
62 62
Your StudioLive features a 32x18 FireWire interface. You can record any input
and bus with a Select button, plus the Solo bus, tape input, and talkback
mic, with any audio-recording application that supports Core Audio or ASIO.
Please consult the documentation that came with your audio application
for specific instructions on how to select the StudioLive driver as the audio
device driver for your software. Note that your StudioLive uses the same
driver as the PreSonus FireStudio family of interfaces, so its driver will be
displayed as "PreSonus FireStudio" in all driver-selection menus.
Complete setup instructions for PreSonus Studio One Artist and a brief
tutorial on its features are located in Section 7.4 of this manual. Below are
basic driver-setup instructions for four other popular audio applications.
1. Launch Logic Pro/Express.
2. Go to Logic | Preferences | Audio.
3. Click on the Devices Tab.
4. On the Core Audio tab, check Enabled.
5. Select PreSonus FireStudio from the device menu.
6. You will be asked if you'd like to relaunch Logic. Click "try (re)launch. "
7. Your StudioLive features custom I/O labels for faster workflow. To enable
these labels for use in Logic, go to Options | Audio | I/O Labels.
8. The second column in the popup window will be named
"Provided by Driver. " Activate each of these labels for your
StudioLive. When you are done, close this window.
9. You are now ready to use your StudioLive.
1. Launch Cubase.
2. Go to Devices | Device Setup.
3. Select "VST Audio System" from the Devices column in the Device Setup.
4. Select PreSonus FireStudio from the ASIO Driver dropdown list.
5. Click "Switch" to begin using the StudioLive Driver.
6. Once you have successfully changed the driver, go to Devices |
VST Connections to enable your input and output buses.
1. Launch Sonar.
2. Go to Options | Audio... and click on the Advanced tab.
3. Change the Driver Mode to "ASIO. "
PreSonus StudioLive 16.4.2
™