Installation For Mac Os X; Using The Studiolive As An Audio Interface; Using The Studiolive With Popular Audio Applications - PRESONUS StudioLive 24.4.2 Owner's Manual

6 Connecting to a Computer
6.3

Installation for Mac OS X

6.3
Installation for Mac OS X
After inserting the Installation CD into your disc drive, browse the disc
and run the StudioLive installer, which will take you through each step
of the installation process. Please read each message carefully, and be
especially careful that you do not connect your StudioLive too soon.
64
PreSonus StudioLive ™ 24.4.2
1. You will be directed to the Welcome screen Click
"Continue" and follow the onscreen instructions.
2. You will be directed to choose the hard drive onto
which you want to install the drivers and Universal
Control Panel. You must choose your system drive.
Storage drives and partitions cannot be used as
hosts for the driver.
Once the installation is completed, you will find the
Universal Control program in your Applications folder.
It is recommended that you place this in your Dock.
Click "Install. "
3. When the installation is completed, connect your
StudioLive to your Mac with a FireWire cable and
power it on. You are now ready to use your
StudioLive!
Owner's Manual
6.4

Using the StudioLive as an Audio Interface

Your StudioLive features a 32x26 FireWire interface. Any input and bus with a
Select button, plus the Solo bus, tape input, and talkback mic, can be recorded
with any audio-recording application that supports Core Audio or ASIO.
Please consult the documentation that came with your audio application for
specific instructions on how to select the StudioLive driver as the audio device
driver for your software. It is important to note that your StudioLive uses
the same driver as the PreSonus FireStudio family of interfaces, so its driver
will be displayed as "PreSonus FireStudio" in all driver-selection menus.

6.4.1 Using the StudioLive with Popular Audio Applications

Complete setup instructions for PreSonus Studio One Artist and a brief
tutorial on its features are located in Section 7.0 of this manual. Below are
basic driver-setup instructions for three popular audio applications.
Apple Logic Pro/Express 7+:
1. Launch Logic Pro/Express.
2. Go to Logic | Preferences | Audio.
3. Click on the Devices Tab.
4. On the Core Audio tab, check Enabled.
5. Select PreSonus FireStudio from the device menu.
6. You will be asked if you'd like to relaunch Logic. Click "try (re)launch. "
7. Your StudioLive features custom I/O labels for faster work flow. To enable
these labels for use in Logic, go to Options | Audio | I/O Labels.
8. The second column in the pop-up window will be named
"Provided by Driver. " Activate each of these labels for your
StudioLive. When you are done, close this window.
9. You are now ready to use your StudioLive.
Steinberg Cubase 4+
1. Launch Cubase.
2. Go to Devices | Device Setup.
3. Select "VST Audio System" from the Devices column in the Device Setup.
4. Select PreSonus FireStudio from the ASIO Driver dropdown list.
5. Click "Switch" to begin using the StudioLive Driver.
6. Once you have successfully changed the driver, go to Devices |
VST Connections to enable your input and output buses.
Connecting to a Computer 6
Using Your StudioLive as an Audio Interface 6.4
65