Configuring The Studiolive For Core Audio (Mac Only) - PRESONUS StudioLive 16.4.2 Owner's Manual

Owner's Manual

Configuring the StudioLive For Core Audio (Mac Only)

6.4.5
Your StudioLive can be used as the main Core Audio device for a Mac, and you
can route the main outputs of your Mac to any of its available output streams.
By default, these streams are routed to Channels 1 and 2 on your StudioLive.
The obvious limitation of this is that you will use up two input channels on
your StudioLive just for Core Audio playback. Channels 17 and 18 are available
through the FireWire Return buttons inside the 2 Track In and Monitor sections
of the StudioLive, and we recommend that you use these channels for Core
Audio playback. The following instructions will help you configure your
StudioLive to be used as the main audio playback device for your Mac.
Connecting to a Computer
Using the StudioLive as an Audio Interface
2. The WDM Channel Mapper window will open. By
default, WDM Outputs 1 and 2 are routed to
StudioLive Channels 1 and 2. As previously
mentioned, we recommend that they be set,
instead, to Channels 17 and 18, so as not to use
input channels on your StudioLive for WDM
playback. To begin, check the box next to Output.
Click on WDM 1 (front left) and drag it down to
place it next to StudioLive 2 Track In Left. Click on
WDM 2 (front right) and drag it down to place it
next to StudioLive 2 Track In Right.
3. Your stereo WDM playback will now be
routed directly to the main FireWire return
buttons in the 2 Track In and Monitor buses
in the StudioLive Master Section.
1. Go to MacHD | Applications | Utilities and launch
Audio MIDI setup.
Click on the Configure Speakers button.
6
6.4
67 67