Service Table; Service Program Mode; Service Program Access Procedure; Service Program Mode Tables - Ricoh A284 Service Manual

4. SERVICE TABLE

4.1 SERVICE PROGRAM MODE

4.1.1 SERVICE PROGRAM ACCESS PROCEDURE

The service program access procedure, such as "Entering Service Program (SP)
Mode" and "Exiting SP Mode" is the same as for copier and fax, as follows.
Entering SP mode
# →  → →  → F (hold it for more than 3 seconds.)
Exiting SP mode
Press the "Back" and "Exit" keys until the standby mode display appears.

4.1.2 SERVICE PROGRAM MODE TABLES

NOTE: 1) In the Function column, comments are in italics.
2) In the Settings column, the default value is in bold letters.
No.
001 FTP Port Number
002 Compression Type
003 Software Version
004 Program Number
005 Error Log Display
006 Scan Data Reset
007 All Data Reset
SM
Function
Changes the FTP port number.
After changing this value, do the
following:
1. Run the Registry Editor.
2. Access
/HKEY_LOCAL_MACHINE/SOF
TWARE/Ricoh/NetworkScanner
3. Change the value of PortNo to
this SP mode's value.
Selects the compression type for
binary picture processing.
Displays the software version.
Displays the program's part
number.
Displays the error logging data
Check this data when SC4005
occurs. Then inform it to the
service center.
Resets all scanner data (UP and
SP modes) except for the network
interface data (UP-Network-1 ~ 8)
Press "1" three times to reset.
Resets all UP and SP settings
Press "1" three times to reset.
8-11
SERVICE PROGRAM MODE
Setting
00000 ~ 65536
1/step
3670
1: MH
2: MR
3: MMR
B359