Daikin E-Series Service Manual page 239

Instruction
1. What to do before operation
This operation manual is for the following systems with
standard control. Before initiating operation, contact your
Daikin dealer for the operation that corresponds to your
system.
• Pair system
Indoor unit
Outdoor unit
Unit with
remote
control
• Multi system
Indoor unit
Outdoor unit
Unit with
remote
control
NOTE
• If the unit you purchased is controlled by a infrared
remote control, also refer to the infrared remote
control's operation manual.
If your installation has a customized control system, ask your
Daikin dealer for operation that corresponds to your system.
228
Indoor unit
Unit with
remote
control
• Heat pump type
This system provides cooling, heating, automatic, program
dry, and fan operation modes.
• Cooling only type
This system provides cooling, program dry, and fan
operation modes.
Precautions for group control system or two
remote control control system
This system provides two other control systems beside
individual control (one remote control controls one indoor unit)
system. Confirm the following if your unit is of the following
control sytem type.
• Group control system
One remote control controls up to 16 indoor units.
All indoor units are equally set.
• Two remote controls control system
Two remote controls control one indoor unit
(In case of group control sytem, one group of indoor units)
The unit is individually operated.
NOTE
• Contact your Daikin dealer in case of changing the
combination or setting of group control and two remote
controls control sytem.
Names and functions of parts
Refer to figure 2 on page [1]
a Indoor unit
Outdoor unit
• The external appearance of the outdoor unit varies
depending on its capacity class. The outdoor unit
b
shown in the figure is for reference to indicate
features. Contact your Daikin Dealer and verify
which outdoor unit you have.
c Remote control
d Inlet air
e Discharged air
f Air outlet
g Air flow flap (at air outlet)
h Refrigerant piping, connection electric wire
i Drain pipe
Air inlet
j
The built-in air filter removes dust and dirt.
Drain pumping out device (built-in)
k
Drains water removed from the room during cooling.
Ground wire
l Wire to ground from the outdoor unit to prevent
electrical shocks.
SiEN18-621
System Configuration