Outdoor Unit - Daikin E-Series Service Manual

SiENBE18-621

" Outdoor Unit

" Indoor Unit
1. Air filter
2. Air purifying filter with photocatalytic deodorizing
function:
• These filters are attached to the inside of the air filters.t
3. Air inlet
4. Front panel
5. Panel tab
6. Room temperature sensor:
• It senses the air temperature around the unit.
7. INTELLIGENT EYE sensor:
• It detects the movements of people and automatically
switches between normal operation and endergy
saving operation.
8. Display
9. Air outlet
10. Flaps (horizontal blades):
11. Louvers (vertical blades):
• The louvers are inside of the air outlet.
" Outdoor Unit
17. Air inlet: (Back and side)
18. Air outlet
19. Refrigerant piping and inter-unit cable
20. Drain hose
Appearance of the outdoor unit may differ from some models.
System Configuration
12. Indoor Unit ON/OFF switch:
• Push this switch once to start operation. Push once
again to stop it.
• The operation mode refers to the following table.
Temperature
Mode
FTKS COOL
FTXS AUTO
• This switch is useful when the remote control is missing
13. Operation lamp (green)
14. TIMER lamp (yellow)
15. HOME LEAVE lamp (red)
16. Signal receiver:
• It receives signals from the remote control.
• When the unit receives a signal, you will hear a short
beep.
• Operation start .............beep-beep
• Settings changed..........beep
• Operation stop..............beeeeep
21. Earth terminal:
• It is inside of this cover.
22. Outside air temperature sensor: (Back side)
• It senses the ambient temperature around the unit.
Instruction
Air flow
setting rate
22°C AUTO
25°C AUTO
159