Daikin E-Series Service Manual page 190

SiENBE18-621
" To start COMFORT AIRFLOW operation
3.Press "COMFORT AIRFLOW button".
• The flap position will change, preventing air from blowing directly on the occupants of the room.
•
"
<COOL/DRY> The flap will go up.
<HEAT> The flap will go down.
" To cancel COMFORT AIRFLOW operation
4.Press "COMFORT AIRFLOW button" again.
• The flaps will return to the memory position from before COMFORT AIRFLOW mode.
•
"
Notes on COMFORT AIRFLOW operation
• POWERFUL operation and COMFORT AIRFLOW operation cannot be used at the same time.
Priority is given to POWERFUL operation.
Notes on flaps and louvers angles
• When "SWING button" is selected, the flaps swinging range depends
on the operation mode. (See the figure.)
" ATTENTION
• Always use a remote control to adjust the flaps angle. If you attempt to
move it forcibly with hand when it is swinging, the mechanism may be
broken.
• Be careful when adjusting the louvers. Inside the air outlet, a fan is
rotating at a high speed.
System Configuration
is displayed on the LCD.
"
disappears from the LCD.
"
In DRY mode or COOL mode
When stop operation
Upper limit
Lower limit
In HEAT mode
When stop operation
Upper limit
Lower limit
In FAN mode
When stop operation
Upper limit
Lower limit
Instruction
179