Ibm Hardware Management Console For Eserver Pseries (Hmc) To The Primary I/O Book - IBM pSeries 670 Service Manual

IBM Hardware Management Console for Eserver pSeries (HMC) to the
Primary I/O Book
To connect your HMC to the pSeries 670Eserver pSeries 670, connect the serial cable into serial port 1
located on the back of the HMC. Connect the other end of the serial cable into the HMC1 connector
located on the primary I/O book in the managed system. The following illustration shows the location of the
serial ports on the back of the HMC and the HMC connectors located on the processor subsystem.
1 Primary Rack
2 Primary I/O Book
3 Power Plug to External Power Source (wall
plug)
Optional 8-port or 128 Port Async Adapters
Up to two optional async adapters can be installed in the HMC. The adapters have breakout boxes that
allow connection to serial cables that connect to the managed system's HMC 1 serial ports. For
information about installing these adapters in the HMC, see the Eserver pSeries 670 Installation Guide,
order number SA38-0613.
48 Eserver pSeries 670 Service Guide
4 Primary HMC Connected to HMC #1 in Primary
I/O Book (HMC #1 may be labeled HSC #1)
5 Optional Second HMC Connected to HMC #2
in Primary I/O Book (HMC #2 may be labeled
HSC #2)