I/O Subsystems (1 Through 2) Rio-2 Cabling To I/O Books, One I/O Planar Loop Configuration - IBM pSeries 670 Service Manual

Hide thumbs Also See for pSeries 670:

Table of Contents

I/O Subsystems (1 through 2) RIO-2 Cabling to I/O Books, One I/O

Planar Loop Configuration

Note: The following figure applies to CECs with RIO-2, or bayonette retention, connections.

1 Primary Rack

2 Primary I/O Book

3 Second I/O Subsystem

Note: The maximum number of I/O subsystems that can be attached in the one planar loop configuration is 2, or four

I/O planars. Only eight RIO or RIO-2 ports are available in the CEC. The last two CEC RIO ports must only be used

Eserver pSeries 670 Service Guide

4 First I/O Subsystem

5 Secondary I/O Book

for single I/O planar loop connections.

Chapters

Table of Contents