Hardware Management Console For Pseries (Hmc) To The Primary I/O Book - IBM eserver pSeries 690 Installation Manual

Hardware Management Console for pSeries (HMC) to the Primary I/O Book

To connect your HMC to the pSeries 690, connect the serial cable into serial port 1
located on the back of the HMC. Connect the other end of the serial cable into the
HMC1 connector located on the primary I/O book on the managed system. The
following illustration shows the location of the serial ports on the back of the HMC and
the HMC connectors located on the processor subsystem.
1
2
3
94
pSeries 690 Installation Guide
Primary Rack
Primary I/O Book
Power Plug to External Power Source
(wall plug)
4 Primary HMC Connected to HMC #1 in
Primary I/O Book (HMC #1 may be
labeled HSC #1)
5 Optional Second HMC Connected to
HMC #2 in Primary I/O Book (HMC #2
may be labeled HSC #2)