Table of Contents
Advertisement
SA-NC9GC / SA-NC9GS / SA-NC9GCS / SA-NC9GN
9.3.3.
ECC Error Code Table
Error Code
Diagnosis Contents Description of error
F600
Administrative
information cannot be
acquired by the
recovery error.
F601
Irregular sector ID
wad demanded.
F603
KEYDET cannot be
acquired by the
recovery error.
Note:
An error code will be cancelled if a power supply is turned OFF.
*1: CPPM is the copy guard function beforehand written in the disc for protection of copyrights.
*2: CEC is the consumer electronic control used for high-level user control HDMI-connected devices.
*3: HDCP is the specification developed to control digital audio & video contents transmission for DVI or HDMI connections.
9.3.4.
USB Error Code Table
Error Code
Diagnosis Contents Description of error
F650
USB device: Devices
other than mass
storage
F651
USB device: Non-Full
Speed Device
F652
USB device: Interface
NG
F655
USB device:
Overcurrent detection
9.4.
Doctor Mode
To enter into Doctor Mode, special remote control needed.
It
become
impossible
NaviPack
etc.
were
done, and not to be able
to
acquire
necessary
information
in
the
navigation's
changing
due to wound etc. of
DISC, and to have done
the
reproduction
transition.
It tried to access the
position that did not exist
on
DISC
by
the
recording error etc. of
authoring.
The data for decoding
copyright
protection
(CSS)
cannot
be
acquired due to wound
etc. of DISC, and it is not
possible to reproduce.
Devices other than the
mass storage class are
connected.
The
device
that
the
transfer
rate
did
not
correspond
to
Full
Speed was connected.
The
device
in
the
interface
(subclass)
outside correspondence
was
connected.
(Correspondence
interface
001b:
Reduced
Block
Commands (RBC)
010b: SFF-8020i. MMC-
2 (ATAPI)
110b: SCSI transparent
command set.
The
overcurrent
of
500mA or more was
detected in VDD USB,
and the USB device
driver
function
was
intercepted.
(To
intercept the current.)
Automatic FL Display
Automatic FL Display
38
Remarks
Press [
] on main unit for
next error.
Press [
] on main unit for
next error.
Press [
] on main unit for
next error.
Remarks
Press [
] on main unit for
next error.
(The generation D110, it mounts.)
Press [
] on main unit for
next error.
(The generation D110, it mounts.)
Press [
] on main unit for
next error.
(The generation D110, it mounts.)
Press [
] on main unit for
next error.
(The generation D110, it mounts.)
Advertisement
Table of Contents
