Panasonic SA-NC9GC Service Manual page 29

Item
Mode Name
Initial setting of Initial setting of laser drive current.
laser drive current Initial current value for the DVD laser
and CD laser is separately saved in
the EEPROM IC.
FL Display sequence
Display 1 → 2
9.2.2. Service Mode Table 2
Item
Mode Name
DVD laser drive DVD laser drive current
current measurement.
measurement DVD laser drive current is measured
and the result is displayed together
with the initial value stored in the
EEPROM IC.
After the measurement, DVD laser
emission is kept on. It is turned off
when POWER key is switched off.
FL Display sequence
Display 1 → 2
ADSC internal ADSC internal RAM data check.
RAM data check ADSC internal RAM data is read out
and displayed.
Description
1. (Display 1)
The measurement value in decimal
notation
2. (Display 2)
The value denotes the current in decimal
notation. The above example shows the
initial current XXXmA and YYYmA for DVD
laser and CD laser respectively when the
laser is switched on.
Description
1. (Display 1)
2. (Display 2)
The value denotes the current in decimal
notation.
The above example shows the initial
current is XXXmA & YYYmA for the
measured value.
The value is shown in hexadecimal notation.
The above example shows the data in
ADSC address FBOh is XXXXh.
FL Display
FL Display
29
SA-NC9GC / SA-NC9GS / SA-NC9GCS / SA-NC9GN
Key Operation
Front Key
In STOP (no disc) mode, press
[ ] button on the main unit,
and [ , PAUSE] button on the
remote control unit.
Cancelled automatically 5 seconds
later.
Key Operation
Front Key
In STOP (no disc) mode, press
[ ] button on the main unit,
and [FUNCTIONS] button on the
remote control unit.
Cancelled automatically 5 seconds
later.
In STOP (no disc) mode, press
[ ] button on the main unit,
and [1] button on the remote control
unit.
To exit, press [ ] button.