Panasonic SA-NC9GC Service Manual page 33

9.2.4. Service Mode Table 4
Item
Mode Name
DVD (HDMI) module DVD (HDMI) module firmware version
firmware version is displayed on the FL Display.
The firmware version can be updated
display
using recovery disc.
Note: It is necessary to check for
firmware version before carrying out
the version up using the disc
Communic- Displays frequency of communication
ation error display errors between system control IC and
mechanism control IC in the DVD
(HDMI) Module P.C.B.
ECC error check ECC refers to Error correction code. It
describes the error correction code
that was carry out for the decoding of
audio & video.
FL Display sequence
Display 1 → 2
CPPM/CRM Keys CPPM/CPRM refers to the content
Check protection for Recordable Media &
Pre-Recorded Media. It displays the
existence of the keys as "1" or "0".
DVD (HDMI) Module To reset DVD (HDMI) Module P.C.B.
Reset This process is used when the DVD
Module or Flash ROM IC is replaced
with a new one.
Description
(Display 1)
(Display 2)
FL Display
33
SA-NC9GC / SA-NC9GS / SA-NC9GCS / SA-NC9GN
Key Operation
Front Key
In STOP (no disc) mode, press
[ ] button on the main unit,
and [8] button on the remote control
unit.
Cancelled automatically 5 seconds
later.
In STOP (no disc) mode, press
[ ] button on the main unit,
and [MENU] button on the remote
control unit.
Cancelled automatically 5 seconds
later.
In STOP (no disc) mode, press
[ ] button on the main unit,
and [TOP MENU] button on the remote
control unit.
Press [ ] button to exit.
Press [FL Display] button on remote
control unit for next page (FL Display).
In STOP (no disc) mode, press
[ ] button on the main unit,
and [EQ] button on the remote control
unit.
Cancelled automatically 5 seconds
later.
While in initialization mode, press and
hold [ ] button on the main
unit, follow by [Enter] button on the
remote control.
Cancelled automatically 5 seconds
later.