Panasonic SA-NC9GC Service Manual page 61

Step 2 Raise the CD Loading unit vertically.
Step 3 Slide the lever fully in the direction of arrow, pull the tray
out. (The sub tray and tray be out together).
Note:
Tray cannot be take out when CD Loading unit place in horizon
even pushing lever.
Step 4 Spread the tabs at the both side. (The tray slides a little
forward and stops.)
Step 5 Hook the drive arm hanging area over the tray slider
and tray.
Step 6 Pull out tray and sub tray.
Step 7 Release the vertically lock lever, free the sensor lever.
Step 8 Pull the sub tray.
· Assembly of the tray
Step 1 Insert a part of the tray and sub tray into the unit sliding
over the groove on the mecha chassis.
Step 2 Insert the tray to the point before the tab of the mecha
chassis.
61
SA-NC9GC / SA-NC9GS / SA-NC9GCS / SA-NC9GN