Panasonic SA-NC9GC Service Manual page 37

Error Code Diagnosis Contents Description of error
U703 HDMI/DVI attestation
error
U704 HDMI/DVI SRM
Riborserar
U705 HDMI/DVI SRM disc
falsification check
error
F893 FLASH ROM IC data
falsification error
F894 EEPROM IC
abnormality error
F895 Language area
abnormal
F896 No existence model
F897 Initialization error
F898 Disagreement of
hardware and
software
F899 The communication
specification
disagreement
between micro-
processor
9.3.2. Power Supply Error Code Table
Error Code Diagnosis Contents Description of error
F61 The abnormalities in
an output or power
supply circuit of
POWER AMP
F76 Abnormality in the
output voltage of
stabilized power
supply
When attestation
(HDCP) with the TV side
fails when connecting it
with HDMI/DVI, it is
generated.
It is generated at the
equipment to which the
TV set is Riborced when
connecting it with
HDMI/DVI.
It is generated at the
time of it is time when
illegal the SRM data of
the reproducing disc
(verify error). When
connecting it with
HDMI/DVI.
Firmware error, DV 5.0
LSI IC (IC8651) error.
When failing in the
access to EEPROM IC
located in the DVD
(HDMI) Module P.C.B.
(IC8611)
Firmware version
agreement check for
factory preset setting
failure prevention.
Firmware version
agreement check for
factory preset setting
failure prevention.
Incomplete initialization
after writing of new
firmware (Factory preset
setting failure
prevention).
Unsuitable combination
of AV Decoder, SDRAM
& FLASH ROM IC
(firmware).
Unsuitable combination
of number of system
com and panel com
used. (Firmware)
In normal operation,
when DCDET2 goes to
"L" (not during power-off
condition), F61 appears
on FL display and
PCONT goes to "L". This
is due to speaker output
has DC voltage or fan is
not working.
In normal operation
when DCDET1 is
detected L (Low) for two
consecutive times, F76
is displayed on FL for 2
seconds and after that
PCONT will be turned to
L (Low). This is due to
any of the DC voltages
(+9V) +7V, -7V, +5V,
+5.3 etc) not available.
Automatic FL Display
Automatic FL Display
37
SA-NC9GC / SA-NC9GS / SA-NC9GCS / SA-NC9GN
Remarks
Press [ ] on main unit for
next error.
Press [ ] on main unit for
next error.
Press [ ] on main unit for
next error.
Press [ ] on main unit for
next error.
Press [ ] on main unit for
next error.
Press [ ] on main unit for
next error.
Press [ ] on main unit for
next error.
Press [ ] on main unit for
next error.
Press [ ] on main unit for
next error.
Press [ ] on main unit for
next error.
Remarks
Press [ ] on main unit for
next error.
Press [ ] on main unit for
next error.