Setting Energy Saver Function - Kyocera TASKalfa 1801 Operation Manual

Installing and Setting up the Machine > Default Settings of the Machine

Setting Energy Saver Function

To use the Energy Saver function, configure the following settings:
• Sleep and Sleep Timer (page 2-20)
• Power Off Timer (page 2-22)
Sleep and Sleep Timer
Sleep
To enter Sleep, press the
[Energy Saver] indicators. This status is referred to as Sleep.
If print data is received during Sleep, the print job is performed while the message display remains unlit.
When using the optional FAX, received fax data is printed out while the message display also remains unlit.
To use the machine, press any key on the operation panel.
The machine will be ready to operate within 11 seconds.
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Sleep Timer
Sleep Timer automatically switches the machine into Sleep if left idle for a preset time.
The default preset time is 1 minute.
To change the preset sleep time, refer to
Follow the steps below to set the sleep timer for the machine to go into sleep mode when not in use.
1
[Energy Saver] key. All indicators on the operation panel will go out to save power except the
Sleep Timer on page
Display the screen.
1
Press the [Status/System
2
Press the [▲] or [▼] key to select [Common Settings], and press the [OK] key.
Status/Sys. Menu:
System
04
05 Admin/Accounting
06 Common Settings
Exit
7-17.
Menu/Counter] key.
1
2-20
2