Yamaha XVS650 Service Manual page 338

I!llnside the motorcycle.
lID
Place the end of the plastic locking tie as
shown.
[g Fasten the rear brake switch lead, sidestand
switch lead and rectifier/regulator lead with
metal clamp or plastic locking tie.
[QJ Pass the front flasher light leads (left and right) and
headlight lead through the headlight cover hole.
[§] Pass the left handlebar switch lead behind the
upper bracket.
[£] Fasten the left handlebar switch lead with a
plastic locking tie.
CABLE ROUTING
ISPECI
0-1
[§] Pass the speedometer cable, speedometer
light leads and fuel tank breather hose through
the fuel tank hole.
[8] To the speedometer light leads.
en
Pass the right handlebar switch lead and head-
light lead over the other harness and leads.
QJ Pass the clutch cable through the cable guide.
00
Fasten the sidestand switch lead and rectifier/
regulator lead with a plastic locking tie.
l!J
Install the plastic locking tie so that it is up
against the frame projection.
!MI
To the engine.
[ffi The sidestand switch lead should not touch the
shift rod.
D
0 : =
-5 -