Yamaha XVS650 Service Manual page 184

MIDDLE GEAR
ENG
tt>.
7.1nstall:
• Bearings
CD
(onto the cross joint)
The needles can easily fall out of their
races, so check each bearing. Slide the uni-
versal joint yoke back and forth on the
bearings. If a needle is out of place the
yoke will not go all the way onto the bear-
ing.
8.Using a suitable socket press each bear-
ing into the hole on yoke.
NOTE: _
The bearings must be inserted far enough
into the cross joint so that the circlips can
be installed.
9.lnstall:
• Circlips
®
(into the groove of each bearing)
10.lnstall:
• Middle driven pinion gear assembly
NOTE: _
Just finger tighten the bolts at this stage.
NOTE: _
When installing the shims, make sure that
the tabs
®
are positioned correctly.
4 - 77
11.1nstall:
• Shims
CD
• Bolts
~25
Nm (2.5 m . kg, 18.1 ft . Ib)
I