DataCard CD Series Installation And Manual page 58

YMCPowerNosRGB ‐ Modify the intensity when printing without the sRGB
•
color mode.
Increase the value to make the non‐sRGB color darker
Decrease the value if using non‐sRGB color mode to prevent overly dark
printing or ribbon wrinkles or tears.
YMCWhiteShade ‐ Modify the amount of power applied to the printhead to
•
reduce ribbon friction without transferring material. Decrease the value if
unprinted or white areas of the card have color applied to them and should
not.
Pick
Pick settings are available for WebService access‐level users only. Contact your
service provider for information about changing the printer's pick settings.
Transport
Description
1) EjectHopperSpeed
2) TransMedSpeed
Change settings as needed, and then click Set Current to apply changes.
EjectHopperSpeed ‐ Optimize eject speed based on hopper type.
•
Select ehs_Standard if the printer has a standard hopper.
Select ehs_Extended if the printer has an extended hopper.
TransMedSpeed ‐ Set the speed at which to run the transport motor when
•
clearing errors.
Flipper
Flipper settings are used to set values for the duplex module in duplex‐option
printers. Flipper settings are available for WebService access‐level users only.
Contact your service provider for information about changing the printer's flipper
settings.
50
Default Value Current Value (unit)
ehs_Standard ehs_Standard
800 800
Allowed
Range
[300-1800]
Printer Manager