Table of Contents
Advertisement
PC-D320/PC-D340/FAX-L400 Chapter 4: Maintenance and Service
#005 [TX/RX] Initial identification (T0/T1) time-over
Cause:
Solutions:
Cause:
Solutions:
Cause:
Solutions:
Cause:
Solutions:
Cause:
Solutions:
Cause:
Solutions:
#009 [RX] Recording paper has jammed or the recording paper has run out
Cause:
Solutions:
Cause:
Solutions:
Cause:
Solutions:
Tone/pulse parameter set incorrectly.
Set the user data "TEL LINE TYPE" tone/pulse parameter correctly.
The time until connection with the other fax is too long.
(1)
When registering for auto dialing, add a long pause to delay the
start of the timer.
(2)
Lengthen the T0 timer with Service Data #3 Numeric param.10 so
that the timer does not time out.
The other fax does not answer.
Contact the other party and have them check for the cause.
A significant signal has not been received after starting transmitting
theDIS signal.
Lengthen the T1 timer (Rx) with Service Data #3 Numeric param.11 so
that the time-out error does not occurr.
The communications mode (G2,G3,etc) of the other fax does not match
that of this fax.
The communications mode is a part of specification for the fax, so there is
no countermeasure.
(1)
The other fax malfunctioned during transmission due to echoes.
(2)
Malfunction due to echoes during reception.
Provide measures against echoing using SW03 of service data #1 SSSW.
The recording paper jammed.
Clear the recording paper jam.
There is no recording paper.
Load recording paper.
Internal structure defect.
(1)
Check if the cassette recording paper sensor, multi-purpose tray
paper sensor are operating correctly using the methodes given in
this chapter, 6.7 Faculty Tests, Test mode [6] Faculty test, [3] Sensor
tests.
(2)
Check the page top sensor, the sensor cable and the ECNT board
(J211) connections.
(3)
Check the paper eject sensor, the sensor cable and the ECNT board
(J210) connections.
(4)
Check the main motor, main motor connector and the ECNT
board(J401).
(5)
Replace the page top sensor.
(6)
Replace the paper eject sensor.
(7)
Replace the main motor.
(8)
Replace the ECNT board.
(9)
Replace the SCNT board.
4-24
Hide quick links:
Advertisement
Table of Contents
