Canon PC-D320 Service Manual page 98

PC-D320/PC-D340/FAX-L400 Chapter 4: Maintenance and Service
• Service error code
No. Tx or Rx
##0100 [TX
##0101 [TX/RX]
##0102 [TX
##0103 [RX
##0104 [TX
##0106 [RX
##0107 [RX
##0109 [TX
##0111 [TX/RX]
##0114 [RX
##0116 [TX/RX]
##0200 [RX
##0201 [TX/RX]
##0220 [TX/RX]
##0223 [TX
##0224 [TX/RX]
##0229 [RX
##0237 [RX
##0238 [RX
##0261 [TX/RX]
##0280 [TX
##0281 [TX
##0282 [TX
##0283 [TX
##0284 [TX
##0285 [TX
##0286 [TX
##0287 [TX
##0288 [TX
##0289 [TX
Definition
] The number allowed for retransmission of the procedure signal
was exceeded during transmission
The modem speed of the machine does not match that of the
other party
] Fallback is not possible
] EOL cannot be detected for 5 sec (15 sec if CBT)
] RTN or PIN has been received
] The procedure singal cannot be received for 6 sec while in wait
] The transmitting machine cannot be use fallback
] After transmitting DCS, a signal other than DIS, DTC, FTT,
CFR, and CRP was received, exceeding the permitted number of
transmissions of the procedure signal
Memory error
] RTN was transmitted
During a communication, suspension of loop current was
detected
] During image reception, a carrier is not detected for 5 sec
DCN was received through a non-normal procedure
System error (e.g., main program may have gone away)
] The line was disconnected during communication
Fault occurred in the communication procedure signal
] The recording system became locked for 1 min
] The IC used to control the decoder malfunctioned
] The unit used to control recording malfunctioned
System error occurred between the modem and system control
board
] The number of re-transmissions of the procedure signal has been
exceeded
] The number of re-transmissions of the procedure signal has been
exceeded
] The number of re-transmissions of the procedure signal has been
exceeded
] The number of re-transmissions of the procedure signal has been
exceeded
] DCN has been received after transmission of TCF
] DCN has been received after transmitting EOP
] DCN has been received after transmitting EOM
] DCN has been received after transmitting MPS
] After transmitting EOP, a signal other than PIN, PIP, MCF,
RTP, or RTN was received
] After transmitting EOM, a signal other than PIN, PIP,MCF,
RTP, or RTN was received
4-18