Table of Contents
Advertisement
Chimney Requirements
•
Use one of the following brands and type of chimney:
• Temco 82
Chimneys Part Numbers
Chimney
Components
12" Chimney Section
18" Chimney Section
24" Chimney Section
36" Chimney Section
48" Chimney Section
Offsets
Flashing
Chimney Cap
Roof Support
Firestop Spacer
Chimney Connection to Fireplace
•
Each brand of chimney has a slightly different outside diameter. To accommodate this, the fireplace
has three "L" brackets (outer liner connectors) on the top of the fireplace can. Center a section of
chimney over the chimney opening and mark the exterior location of the chimney. Then reposition
the "L" brackets, if necessary, so they are directly adjacent the exterior of the chimney. Use a drill
with a 5/16" driver bit to re-install the "L" brackets (use the existing sheet metal screws).
Outer Pipe Brackets
Inner Liner (ledge along
inside accepts differed
sized chimney pipes)
Use sheet metal screws to attach
the outer liner to these brackets.
•
When attaching the chimney to the fireplace, first slide down the inner liner of the chimney pipe into
the inner liner of the fireplace. Certain brands of chimney pipe will stop at the ledge, while others
will insert beyond the ledge. When the chimney pipe is fully seated and aligned, drill three holes in
the chimney pipe where it lines up with the holes in the fireplace inner liner. Secure the fireplace to
the chimney pipe with three sheet metal screws. If there are any large gaps between the chimney
pipe and fireplace, use furnace cement to seal (allow 24 hours to dry before burning the fireplace).
I
NSTALLATION
• Superior TF8
Temco 82
Superior
T F 8
8212D
TF8-12
8218D
TF8-18
8224D
8236D
TF8-36
8248D
TF8-48
8232E
TF8-30, TF8-E30
8206F
8203D
TF8-CTO
8204S
---
• FMI 8DM
FMI 8DM
12-8DM
18-8DM
---
24-8DM
36-8DM
48-8DM
30E-8DM
8-F6
6F8 or 12F8
RTL-8HT
8-54
38 RS
8FS-2
FS-8DM
(C
)
ONTINUED
• Marco 8D
M a r c o
8 D
12 - 8D
18 - 8D
----
36 - 8D
48 - 8D
30E - 8D
12F - 8D
BT - 8D
12CPS - 8D
FS30 - 8D
If the outer pipe does not line up
with the brackets, remove the
brackets and re-attach them to
the top of the fireplace.
Connect the inner pipe to
the inner liner with three
sheet metal screws.
P
13
AGE
Hide quick links:
Advertisement
Table of Contents
