Printhead Unit Removal - Epson LX-300+II RTP Service Manual

EPSON LX-300+II/300+II RTP/1170II

7.1.1 Printhead Unit Removal

1. Remove 1 screw (C.P.B., Screw, 3x14 F/ZN; Torque 0.59-0.78N.m) securing the
printhead to the carriage assembly.
2. Lift the printhead a little bit. Unlatch 2 hooks securing the printhead FFC to
carriage unit.
3. Remove FFC from the printhead.
Check if the printer is powered off before removing the printhead.
C A U T I O N
When the printhead unit is removed or replaced, perform the platen
A D J U S T M E N T
R E Q U I R E D
gap adjustment and Bi-D adjustment.
LX-300+II RTP
Carriage Assembly
DISASSEMBLY AND ASSEMBLY
Printhead
C.P.B., Screw, 3x14 F/ZN
Figure7-1. Printhead Removal
Revision D
FFC
99