Disassembly And Assembly - Epson LX-300+II RTP Service Manual

EPSON LX-300+II/300+II RTP/1170II
About LX-300+II RTP, this service manual has only the chapters of the
DISASSEMBLY AND ASSEMBLY, ADJUSTMENT, Parts List and Exploded
Diagram.

7.1 DISASSEMBLY AND ASSEMBLY

This section explains the disassembly and assembly of LX-300+II. Unless otherwise
specified, assembly can be done in the reverse order of the disassembly procedure.
Anything that service person should pay attention to is described under "Check Point".
Any adjustment required after assembly is described under "Adjustment".
When you have to remove parts that are not described in this chapter, refer to the
exploded diagram on Appendix of this manual.
Remove ink ribbon and paper before disassembling the printer.
C A U T I O N
LX-300+II RTP
The figure below is the disassembly flowchart for main component.
7.1.2 "Upper Housing
7.1.6 "P/S Board Assembly
Flowchart 7-1. Disassembly Flowchart (Main Component)
DISASSEMBLY AND ASSEMBLY
START
7.1.1 "Printhead Unit
Unit Removal"
7.1.4 "Panel Board
7.1.3 "Printer Mechanism
Assembly Removal"
Removal"
Revision D
Removal"
Removal"
7.1.5 "Main Board
Assembly Removal"
98