Panel Board Assembly Removal - Epson LX-300+II RTP Service Manual

EPSON LX-300+II/300+II RTP/1170II
5. Lift the printer mechanism a little bit and remove the harnesses from the main board
assembly.
Printer Mechanism
Figure4-5. Harness Removal
6. Remove the printer mechanism.
When the printer mechanism is removed, perform the Bi-D
A D J U S T M E N T
R E Q U I R E D
adjustment.
When the printer mechanism is replaced, perform the Bi-D
adjustment, top margin adjustment, and bottom margin adjustment.
Disassembly and Assembly

4.2.4 Panel Board Assembly Removal

1.
Main Board Assembly
2.
3.
4.
Disassembly and Assembly
Remove the upper housing. (See 4.2.2 "Upper Housing Unit Removal".)
Disconnect the panel FFC from the connector of the panel board assembly.
Remove 3 screws (C.B.P., Tite, 3x10 F/ZN; Torque 0.78-0.98 N.M.) securing the
panel board assembly to the lower housing.
Remove the panel board assembly from the lower housing.
Panel Board Assembly
C.B.P., Tite, 3x10 F/ZN
Figure4-6. Panel Board Assembly Removal
Revision D
Panel FFC
73