EPSON LX-300+II/300+II RTP/1170II
7.2 Adjustment
When making the adjustment with the adjustment program, follow the steps below.
1.
Hold pressing the two open cover sensors with a clip to set them ON. Refer to the
figure.
Open cover sensor
Figure 7-9. Hold pressing The two open cover sensors
LX-300+II RTP
Clip
Adjustment
2.
Feed the paper as shown in the figure below. (Be sure the LEDs state is as shown
in the figure.)
Tear Off LED (right side)
light on
Figure 7-10. Position of the paper feeding
Revision D
105