FUTABA 4PK-2.4G SuperR Instruction Manual page 93

Gyro mixing adjustment
(Preparation)
・Refer to the gyro instruction manual and connect the gyro
to the receiver. When using remote gain, connect gyro sensi-
tivity adjustment to the 3rd CH of the receiver.
・When using gyro mixing by switching between the NORM
(normal) and AVCS modes, use the function select switch
function (p.96) to set the switch to be used.
Setup items
MODE ：Function ON/OFF
NORM ：NORMAL mode gain
AVCS ：AVCS mode gain
•Select the setting item by
ton
* blinks at the current setup item.
GYC NORM Screen
1
(Gyro mixing type selection)
Operate the (JOG) button up and down and select the set-
ting item "MODE". Select the type by pressing the (+) or (-)
button.
"INH" :Function OFF
"GYC NORM" :NORMAL mode only
"GYC AVCS" :AVCS mode only
"SW SEL" :Switching Normal mode and AVCS mode
Switched in the order shown in the figure below by set SW
2
(NORMAL side gain adjustment)
Operate the (JOG) button up and down and select setting
item "NORM". Adjust the NORMAL side gain with the (+) or (-)
button.
(AVCS side gain adjustment)
Operate the (JOG) button up and down and select setting
item "AVCS". Adjust the AVCS side gain with the (+) or (-)
button.
3
To end setting, return to the opening screen by pressing the
(END) button three times (for direct selection, press the (END)
button once)
Dial / Trim Setting
The gain amount can be adjusted by using the function dial function (p.98).
but-
SW SELScreen
GYC AVCS Screen
Special Mixes "S-MIX" (GYRO MIX)
Switch setting
When using push switch PS1
or PS2 set the switch operation
mode to "ALT".
Shows the gyro mode select
switch mode.
Function selection (MODE)
INH, GYC NORM
GYC NORM, SW SEL
NORMAL / AVCS gain
(NORM / AVCS)
0 ~ 120
Initial value:30
93