FUTABA 4PK-2.4G SuperR Instruction Manual page 127

2
(Select the setting item )
"MODE" by (JOG) button up or down operation, and select
the transfer side and receive
side by (+) or (-) button.
"TRANSFER" :Data transfer side
"RECEIVE" :Data receive side
3
(Type selection of receiving side at the sending side)
Operate the (JOG) button of the sending side T4PKSR up
and down and select the setting item "TYPE" and then select
the receiving side transmitter type with the (+) or (-) button.
Since the receiving side T4PKSR automatically recognizes
(AUTO) the sending side type, it does not have this setting.
4
(Model memory selection)
Select the setting item "MDL"by (JOG) button up or down
operation of both transmitter, and select the transfer model
number and receive side model number by (+) or (-) button.
5
(Data transfer execution)
Select the setting item "EXEC"
by (JOG) button up or down op-
eration of both transmitter.
First, press the receive side "RECEIVE" transmitter (+) and (-)
buttons simultaneously. The message "WAITING! 30S" ap-
pears and count down begins.
Within 30 seconds, press the transfer side "TRANSFER"
transmitter (+) and (-) buttons simultaneously. (If data transfer
is not executed within 30 seconds, an error will be displayed
at the receive side "RECEIVE" transmitter.)
-"COMPLETE!" is displayed on the screen of the receive side "RECEIVE"
transmitter and data transfer is ended.
-If "RCV ERROR!" is displayed on the screen of the receive side "RE-
CEIVE" transmitter, data transfer was not performed normally. Check the
connection and repeat steps 1
transmitter only sends, "COMPLETE!" is displayed even when data transfer
was not performed normally.
When the receiving side is a T4PK Super and "RCV ERROR!" was dis-
played on the screen check that sending side "TRANSFER" T4PKSR TYPE
is set to SUPER.
4. Since the transfer side "TRANSFER"
Data Transfer "DTTRN"
Setup item selection
- Select by (JOG) button up or
down operation.
Mode change button
- Use the (+) and (-) buttons to
make adjustments.
Mode selection
"TRANSFER" "RECEIVE"
Model number selection
- Use the (+) and (-) buttons to
make adjustments.
Model# and model name of data
sending and receive side.
Transfer execution button
- (+) and (-) buttons pressed
simultaneously for about 1 sec-
ond.
30 seconds wait is displayed on
the receive side screen.
Error
127