FUTABA 4PK-2.4G SuperR Instruction Manual page 25

3
Pull out the wiring as far as possible from between the wheel unit and APA. Stow the
surplus pulled out wiring in the transmitter.
•Be careful not to stretch the wiring.
4
Install the assembled wheel unit and APA
to the transmitter using the screw supplied.
The APA mounting screws are in the hook
and APA mounting screws bag.
Verify the position of the transmitter bottom
holes by mounting angle. The screw used
depends on the position of the bottom hole.
(Using a 2.0 mm hex wrench.)
5
Install the steering wheel
using the screw.
(Using a 2.5 mm hex wrench.)
Stow the surplus wiring here.
*The figure below is an installation example.
Dummy screws (4 x 4 screw)
hide the APA hole where there is
no bottom hole in the transmitter.
Dummy screw
Use (3 x 20 tapping screw) to install the APA at the 3
bottom holes in the transmitter
Steering wheel mounting screw
Transmitter bottom hole
25