FUTABA 4PK-2.4G SuperR Instruction Manual page 51

Throttle (EPA) adjustment
(Preparation)
- Before setting the throttle end point adjustment (EPA), set the
throttle ATL dial (initial setup: DL2) to the maximum throttle
angle position 100%.
- Select the setting item "TH-FWD" by (JOG) button up or
down operation and make the following adjustments:
1
Throttle (forward side) adjustment
Pull the throttle trigger fully to the high side and use
the (+) or (-) buttons to adjust the throttle angle.
However, when using an FET amp, set to 100%.
2
Throttle (brake side/reverse side) adjustment
Move the throttle trigger fully to the brake side and
use the (+) or (-) buttons to adjust the throttle angle.
However, when using an ESC, set to 100%.
3
When adjusting the throttle angle of another channel imme-
diately after this, see the adjustment method for that channel.
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
If CUT OFF , (which prohibits trigger brake side operation in the boat mode (p.78) ), is
" "
set, throttle TH-BRK
"
3rd & 4th channel servo (EPA) adjustment
(Preparation)
- Select the setting item "3C-UP" or "4C-UP" by (JOG) button up
or down operation and make the following adjustments:
1
3rd/4th channel servo (up side) adjustment
Set the 3rd or 4th channel dial fully to the up side (+ side)
and use the (+) or (-) buttons to adjust the servo angle.
2
3rd/4th channel servo (down side) adjustment
Select the setting item "3C-DWN" or "4C-DWN" by (JOG)
button up or down operation and set the 3rd or 4th channel
dial fully to the down side (-) and use the (+) or (-) buttons to
adjust the servo angle.
3
When adjusting the servo angle of another channel immedi-
ately after this, see the adjustment method for that channel.
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
(brake side) cannot be adjusted.
"
End Point Adjuster "EPA"
100%
Adjust button
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value "100"
by pressing the (+) and (-) but-
tons simultaneously for about 1
second.
- Please see previous note on
page 50.
Throttle EPA
TH-FWD :0~120
TH-BRK :0~120
Initial value :100
Direction selection
- Select by (JOG) button up or
down operation.
Adjust button
Adjust with the (+) and (-) but-
tons.
- Return to the initial value "100"
by pressing the (+) and (-) but-
tons simultaneously for about 1
second.
- Please see previous note on
page 50.
3rd & 4th channel EPA
3/4C-UP :0~120
3/4C-DWN :0~120
Initial value :100
51