LOWR
Checking the propeller shaft
1. Check the propeller shaft for bends or
wear. Replace if necessary.
2. Check the dog clutch, shift plunger, and
spring for cracks or wear. Replace if nec-
essary.
Assembling the propeller shaft
assembly
1. Insert the spring 1, and then install the
dog clutch 3 into the propeller shaft 2.
NOTE:
To install the dog clutch, push the spring
down with a flat head screwdriver 4.
6-9
Lower unit
Assembling the propeller shaft
housing
1. Install the bushing 1 into the propeller
shaft housing.
NOTE:
Insert the dog clutch into the bushing slit at a
90° angle as shown in the illustration.
Needle bearing attachment 2:
90890-06615
Driver rod L3 3: 90890-06652
2. Apply grease to the new oil seals 4, and
then install them into the propeller shaft
housing to the specified depth.
Needle bearing attachment 5:
90890-06617
Driver rod L3 6: 90890-06652
Depth a: 1.0–1.5 mm (0.04–0.06 in)
69M3E11