Yamaha F2.5A Service Manual page 95

6. Install the connecting rod cap A to the
connecting rod, and then tighten the con-
necting rod bolts to the specified torques
in two stages.
e
NOTE:
• Apply engine oil to the connecting rod cap
and connecting rod bolts before installation.
• Align the marks e on the connecting rod
cap and connecting rod.
Connecting rod bolt:
1st: 5 N·m (0.5 kgf·m, 3.7 ft·lb)
2nd: 9 N·m (0.9 kgf·m, 6.6 ft·lb)
7. Install the valve lifters B into the cylinder
block.
69M3E11
8. Set the camshaft C into the cylinder
block as shown.
A
NOTE:
S69M5980
Align the crankshaft mark f and the cam-
shaft mark g.
9. Install the oil splasher gear D, and then
tighten the bolt to the specified torque.
10. Install the dowel E, new gasket F, and
the washer G.
G
E
B
CAUTION:
Do not reuse the crankcase gasket,
E
always replace it with a new one.
S69M5990
Cylinder block
E
F
D
Oil splasher gear bolt:
13 N·m (1.3 kgf·m, 9.6 ft·lb)
1
C
g
2
f
S69M5A00
3
4
5
6
S69M5A10
7
8
9
5-34