Yamaha F2.5A Service Manual page 115

3. Install the shift rod 1 to the joint 2, and
then tighten the bolt 3 to the specified
torque.
Joint bolt 3:
10 N·m (1.0 kgf·m, 7.4 ft·lb)
4. Install the propeller and propeller nut 4.
Place a block of wood between the anti-
cavitation plate and propeller to keep the
propeller from turning, and then tighten
the nut. If the holes in the propeller nut 4
do not align with the cotter pin hole,
loosen the nut until the holes are aligned.
69M3E11
WARNING
• Do not hold the propeller with your
hands when loosening or tightening it.
• Be sure to disconnect the spark plug
cap from the spark plug and the clip
from the engine shut-off switch.
• Put a block of wood between the anti-
cavitation plate and propeller to keep
the propeller from turning.
S69M6470
Drive shaft and lower case
1
2
3
4
5
6
7
8
9
6-16