Konica Minolta bizhub C525 User Manual page 586

Utility
8
Check that the distance from the starting print position of the test pat-
tern to the edge of the paper (b) is 3 mm (± 0.5 mm).
– If the distance is less than 2.5 mm, touch [+] to increase the adjust-
ment (between 0.2 mm and 3.0 mm).
– If the distance is more than 3.5 mm, touch [–] to reduce the adjust-
ment (between –0.2 mm and –3.0 mm).
– If the distance is between 2.5 and 3.5 mm, skip to step 10.
– Each time [+] or [–] is
touched, the value is
increased or de-
creased by one in-
crement.
9
Press the [Start] key.
The adjusted test pattern is printed.
10
Adjust the distance from the starting print position of the test pattern to
the edge of the paper.
– Check that the distance has been adjusted to between 2.5 and 3.5
mm.
– If more adjustment is necessary, repeat steps 8 and 9.
– To adjust the print position for a different paper tray, return to step
6.
11
Touch [OK].
– To cancel changes to the settings, touch [Cancel].
The print position is adjusted.
Note
Enter the value by mm using the keypad.
Refer to the conversion rate below.
1 in. = 25.4 mm
C252
b: 3.0 mm ± 0.5 mm
12
b
12-53