Radio Reassembly - Detailed; Chassis Assembly Reassembly; Chassis And Front Cover Reassembly - Motorola MTP700 Detailed Service Manual

MAINTENANCE

Radio Reassembly - Detailed

Chassis Assembly Reassembly

1. Reassemble the O-ring. The tabs on the O-ring should reach around the chassis and
2. Place the eight small O-ring retainers into their slots in the chassis.
NOTE When properly assembled, the retainers on the O-ring should align with the slots on the
chassis. If this is not the case, remove and replace the O-ring until it is aligned with the
chassis and completely seated in place around the perimeter.
3. Make sure the battery contact module is properly sealed on the RF board.
4. Place the main board and secondary shield straight down on top of the chassis.
5. Use the TORX™ screwdriver with a T6 head to fasten the 5 screws holding the sec-

Chassis and Front Cover Reassembly

1. Align the chassis assembly end-to-end with the front cover assembly.
2. Insert the tails of the flex circuits into their respective connectors at the bottom of the
3. Push down the latches on the connectors to hold the flex circuits to the main board.
4. Attach the UC flex circuit tail to the socket connector.
5. Slide the Talkgroup switch shaft into position in the front cover.
6. Push the chassis assembly completely into the top of the front cover until it settles in
7. Be sure the O-ring is properly seated.
8. Snap the bottom of the chassis into the front cover.
9. Reassemble the Talkgroup knob, antenna and battery.
MTP700 Portable Radio / Detailed Service Manual
point down.
ondary shield and main board to the chassis. Torque the screws to 0.3Nm (3lbf.in).
front cover.
place.
6 - 9