Network Settings; Key Operator Mode - Panasonic DP-C406 Operating Instructions Manual

Network Settings

7Network Settings
In the Network Settings, the following items can be set.
The Key Operator Password is required to open the Network Settings screen.
After setting parameters for the Network Settings, turn the machine's power switch Off, and then On again.

Key Operator Mode

No. 0 - 4
No. Parameter
00 Print Network Settings
01 General
84
Comments
Print the Network Settings list.
To cancel printing the parameter setting list,
select "Stop" and "OK". While processing the
cancellation, panel operation is denied, and an
error beep is produced.
The feeding paper(s) will be ejected before
completing the above cancellation operation.
If setting a parameter, an asterisk mark (*) will
be added before the parameter number.
00 Ethernet
• 00 MAC Address
Displays the MAC address (Ethernet
address).
The MAC address is displayed, but cannot be
set.
• 01 LAN Speed/Duplex
Set the LAN speed.
• 02 Jumbo Frame
Set whether to use Jumbo Frame.
This function is only available when the
machine is connected to 1000 Base- T
Ethernet LAN.
When set to "On", MTU (Maximum
Transmission Unit) is 9000 bytes.
01 IPv4
• 00 DHCP Default
Select "Yes" when your network environment
is based on DHCP server.
When using this machine as a network
shared printer, select "No", and set "01 TCP/
IP Address", "02 TCP/IP Subnet Mask", and
"03 TCP/IP Default Gateway".
Selective Item Standard
Setting
Stop, Start Start
Auto, 10MHalf, Auto
10MFull, 100MHalf,
100MFull, 1GHalf,
1GFull
Off, On Off
No, Yes Yes