Table of Contents
Advertisement
setup screen
va / mD
This can be set to generate an event signal when a motion or intelligent video analysis event
is detected.
1. From the Setup menu, select the
<event (
2. Click <va / mD>.
DIS cannot be used if VA/MD is used.
J
`
` to use motion detection (mD)
1. Select a motion detection mode.
2. Set <motion Detection function> to
<enable>.
3. Set the area of motion to be detected.
• Minimum Object Size : To set the
minimum size of detected motions,
select <minimum object Size> and
then point and drag to the desired
size on the screen using the mouse.
• Maximum Object Size : To set the
maximum size of detected motions,
select <maximum object Size> and
then point and drag to the desired size on the screen with your mouse.
• Detection area : Detect the occurrence of change in the motion of objects in user
set area.
Motions smaller than the specified minimum size or bigger than the maximum size are not
`
J
detected. To avoid unintended detections caused by great and small noises, set minimum/
maximum motion sizes appropriately in accordance to your environments.
Note that same motions on the same location can be differently detected in their detection size;
it is recommended to consider and include the tolerable difference when setting the minimum/
maximum detection sizes.
4. Set the sensitivity to distinguish the background and motion on the monitored screen.
5. Specify the activation time and activation condition.
For more information about <Activation time> and <Action>, refer to "Alarm input". (page 97)
`
6. When done, click [apply (
98_ setup screen
)> tab.
)].
Advertisement
Table of Contents
