Table of Contents
Advertisement
setup screen
• Action : PT limiting operation is set.
- [
- [
- [
input dialog.
Smart codec setup
Set a desired area of the video incoming from the camera as ROI area and specify the
detection sensitivity for the area.
1. From the Setup menu, select the
<audio & video (
2. Click <Smart codec setup>.
3. Select ROI Area.
• Face Detection : Active if a face is
recognized on the monitoring screen.
Face detection is enabled only if the
`
M
following conditions are met:
-
-
-
• Manual : Specify the ROI area to monitor manually.
4. Select a quality for the ROI area.
5. If manually specifying the ROI area, select a desired area with the mouse pointer and
drag it as much as you want.
You can specify up to 5 distinct areas.
`
6. To cancel your selection, simply click [
7. When done, click [apply (
The Smart codec will not be active if it is set to <Off> in <Video profile>. (page 64)
J
`
76_ setup screen
] : Start limit setting.
] : Provide the start and end points.
] : If you want to change the point setting, click this to return to the
)> tab.
The face is positioned at ±45
degrees to the left or right from the top.
The effective range of the face rotation is ±30 degrees vertically, and ±60 degrees horizontally.
The minimum size of the face is 20x20 based on the resolution of 320x240.
].
)].
Advertisement
Table of Contents
