Table of Contents
Advertisement
network disconnect
This can be set to generate an event signal when the physical network connection is cut
off.
1. From the Setup menu, select the
<event (
)> tab.
2. Click <network disconnect>.
3. Specify the use of "Network
disconnect".
4. Specify the activation time and
activation condition.
For more information about <Activation
`
time> and <Action>, refer to "Alarm input".
(page 97)
5. When done, click [apply (
audio detection
You can set to detect sound over the specified level and trigger an event accordingly.
1. From the Setup menu, select the
<event (
)> tab.
2. Click <audio detection>.
3. Set whether or not to <enable>.
4. Set the audio detection's sound level.
The lower the level, the smaller the
sound change is detected.
The audio detection level is designed
`
M
to normalize the input data to a value
between 1 and 100 and detect the signal
larger than threshold level. It is unrelated
to the decibel (dB) level.
5. Specify the activation time and activation
condition.
For more information about < Activation
`
time > and < Action > , refer to "Alarm input". (page 97)
6. When done, click [apply (
If detected audio level is too low, set the audio input gain to a higher level in <Audio setup>.
M
`
)].
)].
English _105
Advertisement
Table of Contents
