Table of Contents
Advertisement
auto network Setup
Run <ip installer_v2.XX.exe> to display the camera search list.
At the initial startup, both [auto Set] and [manual Set] will be grayed out.
For cameras found with the IPv6 setting, these buttons will be grayed out as the cameras do not
`
M
support this function.
1. Select a camera in the search list.
Check the MAC address of the camera
on the camera's label.
Both the [auto Set] and [manual Set]
buttons will be activated.
2. Click [auto Set].
The Auto Setting dialog appears.
The <ip address>, <Subnet mask>,
and <Gateway> will be set automatically.
3. Enter the password.
Enter the password of "admin" account,
which was used to access the camera.
The default password is "4321".
The default password can be exposed to
`
J
a hacking thread so it is recommended to
change the password after installing the
product.
Note that the security and other related
issues caused by the unchanged
password shall be responsible for the
user.
If you want to change the password, refer to "Administrator password change" of the user
`
setup. (page 110)
4. Click [oK].
Auto network setup will be completed.
English _45
Advertisement
Table of Contents
