Table of Contents
Advertisement
13
A S S E M B L Y – G E N E R A L
WITH THE ASSISTANCE OF ANOTHER
PERSON, PERFORM THIS ELECTRODE CHECK
BEFORE PROCEEDING.
This test will ensure that the spark electrode tips are properly
positioned so your barbecue lights easily and properly.
4-5 mm spark
gap
Spark
Spark
receiver
electrode tip
Ensure the gas source is turned off – or is disconnected and
all burner control knobs are set to 'OFF'– and open the lids
/ side shelves.
Have your assistant stand behind to the right of the
barbecue and look toward the front of the barbecue. Never
put your face inside the barbecue.
Press the igniter cap.
sound. Your assistant should see a blue spark within each
gas collector box. If a spark is present the electrode tips
are properly positioned.
If no spark is seen, the spark gap needs to be adjusted as
follows:
•
Using an adjustable spanner, loosen the inside nut
until the gas collector box can be turned upward. If
the gap between the spark electrode tip and receiver is
more than 4 - 5 mm use long nose pliers to gently
squeeze the gas collector box to narrow gap. Return
the gas collector box to its original position, secure the
inside nut and try the electrode check again.
If no 'clicking' sound is heard:
•
AA battery may be installed backwards.
•
Electronic wires may be loose. Remove the AA battery
and inspect the igniter junction box found behind the
control panel and reconnect any loose wires.
• CHECK PERFORMANCE OF
BURNERS PRIOR TO INSTALLING
BARBECUE PLATE COMPONENTRY.
Refer pages 14 and 15 for lighting
instructions
• DO NOT SMOKE WHEN ATTEMPTING
TO IGNITE BARBECUE
• NEVER USE VOLCANIC ROCK,
HEAT BEADS OR OTHER MATERIAL
• ALWAYS USE PROTECTIVE GLOVES
WHEN HANDLING HOT COMPONENTS.
Gas collector
box
Inside
nut
You should hear a 'clicking'
-
+
SIDE BURNER ELECTRODE CHECK
•
Open side burner lid. Remove plastic shipping band
from burner and pot support.
•
Push and turn side burner control knob to 'HI'. Look
for spark between tip of electrode and burner.
•
If you don't see a spark from side burner electrode,
adjust gap between electrode and burner surface to
4 - 5 mm.
FLAME TAMERS
The flame tamer plate is designed to reduce flaring. The
plates fit onto the ledge at the front and rear of the barbecue
body. Position with the slots to the front as shown below.
COOKING PLATES
The grill plates must be positioned over the flame tamers.
Position hot plate and grill
DO NOT COVER ENTIRE COOKING
SURFACE WITH SOLID PLATES,
AS THIS WILL RESULT IN POOR
COOKING PERFORMANCE, OR THE
BURNERS MAY GO OUT, CREATING A
HAZARDOUS SITUATION.
plates as indicated below.
13
Advertisement
Table of Contents
