Assembly & Testing - Rinnai Gourmet 4 Owner's Operation Manual

TOOLS REQUIRED
A Phillips screw driver is all that is required for the assembly of your Rinnai barbecue.
UNPACKING THE BARBECUE
Check for damage. If the barbecue is damaged, contact your supplier for advice. Before installing the
appliance, check it is labelled for the correct gas type (see data plate). Refer to local gas authority for
confirmation of gas type if you are in doubt. Carefully remove packaging and discard / recycle as
appropriate, taking care not to damage any components. The package should contain all items listed
under "Specifications" section. If any items are missing or damaged, DO NOT continue with assembly
and contact your Supplier..
The protective plastic coating MUST be removed from ALL barbecue
components and surfaces, both inside and outside. All surfaces
WARNING
MUST BE thoroughly cleaned before lighting.
This ensures oils and adhesives from the manufacturing process
are removed avoiding appliance discolouration and damage.
ADDITIONAL ASSEMBLY ITEMS (FOR IMPRESSOR SERIES BARBECUES ONLY)
Both the side self and handle are packed separately and will need to be installed.
1. Attach the two angle brackets to the side shelf as shown.
2. Mount the side shelf to the left end of the barbecue, Note: To aid installation the screws marked
"A" use the key-hole mounting method and do not require to be fully removed.
3. Mount the handle to the right end of barbecue.
1
4. For the Impessor 10 the drip tray for the side burners is
shipped separately and will need to be installed, to do this
remove the protective plastic coating from the drip tray.
Slide open the rubbish bin draw and then working from the
left, place drip tray into the bracket located directly under
the fish burner pad.
ADDITIONAL ASSEMBLY ITEMS (FOR GOURMET SERIES BARBECUES ONLY)
The side selves and the gas cylinder bracket are packed separately and will need to be installed.
1. Attach the gas cylinder bracket to the lower right side of the barbecue.
2. Loosen the supporting screws "A" on the left and right sides of the barbecue.
3. Unpack the side shelf as shown.
4. Engage key hole slots over the supporting screws and tighten to secure side shelf in place.
1
Rinnai Australia
ASSEMBLY & TESTING
2
2
Fish Burner Pad
4
Drip Tray
3
- 7 -
3
4
BBQ Owner's Operation Manual