Sony PMW-RX50 Operating Instructions Manual page 86

Warning indication
on LCD
2)
Unknown Media(A)
Please Change
Media Error
2)
Media(A) Needs to be
Restored
Media Error
Cannot Record to
2)
Media(A)
Media Error
Cannot Use Media(A)
Will Switch Slots Soon
No Clip
Cannot Use Media(A)
Unsupported File System
In This File System
Cannot Use Media(A)
Same File Already Exists
3)
Change Media(A)
Video Format Mismatch
Copy Protected Input
Cannot Record
Media Error
Playback Halted
2)
Media(A) Error
Media Reached
Rewriting Limit
2)
Change Media(A)
Reached Clip Number
Limit
Copy Completed to xx/xx
86 Troubleshooting
Buzzer Tally
lamps
2)
3)
2)
Cause and measures
A partitioned memory card or one that contains recorded clips
exceeding the number permitted with this recorder is loaded.
This card cannot be used with this recorder. Remove it and
load a compatible card.
An error occurred with the memory card. The card requires
restoration.
Remove the card, load it again, and restore it.
Recording cannot be done, as the memory card is defective.
As playback may be possible, it is recommended to replace it
with another card after copying the clips, as required.
Neither recording nor playback can be done, as the memory
card is defective.
It cannot be operated with this recorder. Replace it with
another card.
This is an advanced notice that the recorder will switch from
the current memory card to the other memory card for
continuous recording.
There are no clips on the media.
Check the selected card.
A media of a different file system or an unformatted media
was inserted. It cannot be used with this recorder.
Replace it with another card or format it with this recorder.
A memory card that is not compatible with the current file
system is inserted.
Replace the card from the respective slot, format it with the
recorder, or switch the F.Sys. mode.
A clip with the same name exists on the media to which you
want to copy.
Replace the media with different media.
The external signal input via the i.LINK connection cannot be
recorded, as the [Rec Format] setting is different from the
signal format of the external input signal.
Change [Rec Format] in [System] in the [OTHERS] menu to
match it to that of the external signal.
The external signal input via the i.LINK connection cannot be
recorded, as the stream is copy-protected.
Check the input signal.
An error occurred in reading data from the memory card, and
playback cannot be continued.
If this frequently occurs, change the memory card after
copying the clips, as required.
Recording cannot be done, as an error occurred with the
memory card.
If this frequently occurs, change the memory card.
The memory card comes to the end of its service life. Make a
backup copy and replace the card with another one as soon as
possible. Recording/playback may not be performed properly
if you continue to use the card.
The maximum number of clips for the media is reached, so
copying cannot continue. (xx/xx indicates the completed copy
operations.)
Replace the media.