Sony PMW-RX50 Operating Instructions Manual page 51

VIDEO SET
Menu items Setting values
3G SDI OUT LevelA / LevelB
Level A/B
Setting the 3G SDI
output signal
format
SDI/HDMI/ On / Off
Video Out
Super
Setting the
character
information for
each output
Down Squeeze / Letterbox / Edge
Converter Crop
Selecting the
operation mode of
the down converter
23.98P Output 59.94i (2-3PD)/ 23.98PsF
Selecting Output
mode
Off / On
SDI Rec
Control
Setting the
synchronized
recording
Clip Cont. Rec On / Off
Setting
Setting the Clip
Continuous
Recording
function
Segment Loop On / Off
Rec
Setting loop
recording
Segment 15~35min / 30~65min
Duration
Setting loop
recording retention
time
Contents
Select the data mapping method for 3G SDI output signals.
Tips
• Support for Level A is planned for future updates.
• This setting is only enabled when the [SDI/HDMI/i.LINK
I/O Select] is set to [3G (SDI)].
Set whether to add the menus and status indications of the
LCD monitor to the output of the SDI OUT 1/2, HDMI OUT,
and VIDEO OUT connectors.
Note
On the thumbnail, EXPAND CLIP and SHOT MARK
screens, the menus and status indications on the LCD monitor
are displayed regardless of the setting of this item.
Set the output mode (aspect) for SD signals
[Squeeze]: To horizontally reduce a 16:9 picture to output a
4:3 picture
[Letterbox]: To mask the upper and lower areas of a 4:3
picture to display a 16:9 picture in the center of the screen
[Edge Crop]: To cut the both sides of a 16:9 picture to output
a 4:3 picture
Select the output format for the following video formats.
For UDF/HD mode: HD422 50/1080/23.98P, HQ 1920×1080/
23.98P, HQ 1440×1080/23.98P
For exFAT/HD mode: XAVC-I 1080/23.98P, XAVC-L50
1080/23.98P, XAVC-L35 1080/23.98P, HD422 50/1080/
23.98P, HQ 1920×1080/23.98P, HQ 1440×1080/23.98P
For FAT/HD mode: HQ 1920×1080/23.98P, HQ 1440×1080/
23.98P
Select whether to start/stop recording in synchronization with
an REC trigger signal sent from the device connected to the
SDI IN connector.
Turn the Clip Continuous Recording function on/off.
Turn loop recording using two SxS memory cards on/off.
Set the retention time of video during loop recording. Cannot
be selected if the remaining recording time of the SxS
memory cards is less than the capacity required for recording.
Setup Menu List 51