Epson PC AX Technical Manual page 161

REV .A DIASSEMBLY AND ASSEHBLY
5.1.13 Hain (ARTA.) Cireuit Board Removal
1. Remove the upper case.
2. Remove the ANT-ml circuit board.
3. Remove the foul' screws (D) fastening the ANTA board (C) to the lower case.
4. Disconnect the ANTA board connector (F).
5. Open the tabs (E) of the ANTA board towards the sides and slide the ANTA
board out 7
01'
8 cm towards the front.
6. Disconnectg the ANTA board connector (G).
7. Pull the ANTA board out all the way to remove it.
(F)
(H)
(B)
- - (El
-
FIGURE 5-1-7. ANTA CIRCUIT BOARD REt«>V ALlREPLACEMENT
5 .1.14 Hain (ANTA) Cireuit Board Replacement
1. Hold the ANTA circuit board (C) level and slide it horizontally toward the
real' until about 8 cm of clearance remains.
2. Replace the connector (G) on
th~
ANTA board.
3. Slide the ANTA board horizontally to firmly seat
i t
into the ANT-l1T board
connector (H).
Note: Make sure that no cables are held between the ANTA and
AJ1T-MT
boards.
4. Replace the ANTA board connector (F).
5. Replace the ANT-m: board.
7. Replace the upper case.
5-7