Epson Endeavor P60 Specifications

Epson Endeavor P60 Specifications

Hide thumbs Also See for Endeavor P60:

Advertisement

Quick Links

hard disk
diskette
drive
power drive
access light light
access light button
voltage
selector
switch
AC output
socket
\
power
AC input
supply fan
socket

Computer Specifications

CPU and Memory
CPU
Intel Pentium 60 MHZ microprocessor;
backward compatible with 8086, 80286,
I386, and i486 CPUs; supports read and
write burst mode bus cycles; built-in 16KB
write-back cache; integrated math
coprocessor
System speed
High and low speeds available; high speed
is 60 MHz and low speed is simulated
8 MHz for compatibility; speed selection
through Setup program or keyboard
commands
System memory
8MB standard memory on two 4MB
SIMMs; expandable to 128MB using 1MB,
2MB, 4MB, 8MB, 16MB, and 32MB SIMMs
(when readily available); SIMMs must be
32-bit or 36-bit, 72-pin, 70ns or faster,
tin-plated, fast-page mode, parity/no
parity type
diskette
blank filer
power
release
button
panels
expansion
card slots
COM2
LPT
MOUSE
Cache memory
ROM
Video RAM
Shadow RAM
\
VGA
Clock/
calendar
Controllers
Video
Diskette
Hard disk
3/94
EPSON Endeavor P60
Built-in 16KB of internal write-back cache
in the Pentium microprocessor; 256KB of
secondary, direct-mapped, write-through
cache on eight 32KB x 8, 15ns SRAMs on
the main system board; tag and control
logic on the 82434LX PCMC core chip
128KB system and video BIOS located on
a flash EEPROM device; contains Setup
program code, power-on self test code,
update recovery code, and the PCI board
auto-configuration utility; upgradable and
write-protectable
1MB of standard video RAM providing
video resolutions up to 1024
256 colors; expandable to 2MB by
installing eight 256KB
4, 60ns ZIP
X
VRAMs on the main system board to
provide resolutions up to 1280
256 colors
Supports shadowing of system and video
BIOS ROM, and ROM located on
expansion board adapters, into RAM
Real-time clock, calendar, and 128-byte
CMOS RAM (114 bytes for general
purpose non-volatile CMOS RAM and
14 bytes for clock and control registers)
on socketed DS12887 device; integrated
battery and oscillator; CMOS RAM
clearable and resettable using the Setup
program or by setting a main system
board jumper
ATI 68800AX Mach32 local bus PCI
graphics accelerator; compatible with
MDA, CGA, Hercules Graphics, EGA, and
VGA video standards; supports normal
and enhanced video modes; supports
interlaced and non-interlaced monitors
SMC FDC37C665 super I/O controller
with interface on the main system board
controls up to two diskette drives or one
diskette drive and one tape drive; 16-byte
data FIFO (first-in-first-out) with 2.88MB
diskette drive support
SMC FDC37C665 super I/O controller
with interface on the main system board
controls up to two IDE hard disk drives;
BIOS provides hard disk auto-sensing
function
EPSON Endeavor P60 - 1
768 in
x
1024 in
X

Advertisement

Table of Contents
loading

Summary of Contents for Epson Endeavor P60

  • Page 1: Computer Specifications

    Hard disk SMC FDC37C665 super I/O controller tin-plated, fast-page mode, parity/no with interface on the main system board parity type controls up to two IDE hard disk drives; BIOS provides hard disk auto-sensing function 3/94 EPSON Endeavor P60 - 1...
  • Page 2: Power Supply

    To avoid damage to the system board or power supply, do control keypad; 12 function keys not exceed a total of 145 Watts power draw. Stored in ROM; accessible by pressing Setup Program Environmental Requirements during boot 3/94 EPSON Endeavor P60 - 2...
  • Page 3 EPSON Endeavor P60 Main System Board Map 3/94 EPSON Endeavor P60 - 3...
  • Page 4: Simm Installation

    The table below lists possible combinations of SIMMs you can install; do not use any configuration other than one of those listed in the table. SIMM configurations Jumper Settings Main system board jumper settings 3/94 EPSON Endeavor P60 - 4...
  • Page 5: Hard Disk Drive Types

    VRAM ZIP chips (256KB x 4, 60ns, fast-page mode). You must fill all eight sockets. For EPSON monitors, see the second table for information on the monitor type to select. The table below lists the video modes supported by the system.
  • Page 6: Drive Option Information

    CS (cable selection) can be jumpered for any configuration. When Cs is used, the drive is a master if pin 28 is grounded and a slave if pin 28 is not grounded. Diskette drive options EPSON Endeavor P60 - 6 3/94...
  • Page 7: Dma Channels

    Real-time dock User-available User-available I User-available I Onboard mouse port if enabled; otherwise user-available Reserved, math coprocessor IDE if enabled; otherwise user-available User-available DMA Channels Connector Pin Assignments Parallel port connector pin assignments (J13C1) 3/94 EPSON Endeavor P60 - 7...
  • Page 8 1 Activity Ground Speaker connector pin assignments (J1F1) PCI expansion board connector pin assignments Auxiliary 12 V front fan connector pin assignments (J3A1) Signal name Ground +12V (fused) Ground ISA expansion hard connector pin assignments EPSON Endeavor P60 - 8 3/94...
  • Page 9: Error Messages

    Error/External PULL UP 330 Cache Bad Turbo LED connector pin assignments (J1H1) Error messages Signal name PULL UP 330 LED TURBO Video monitor port connector pin assignments (J13A1) VESA feature connector pin assignments (J10A1) 3/94 EPSON Endeavor P60 - 9...
  • Page 10: Tested Operating Environments

    VAC. If the line source voltage in your location is between 200 and 240 VAC, make sure you set the switch to 230 VAC. To avoid damage to the system board or power supply, do not exceed a total of 145 Watts power draw. 3/94 EPSON Endeavor P60 - 10...
  • Page 11: Information Reference List

    Information Reference List Engineering Change Notices None. Technical Information Bulletins None. Product Support Bulletins None. Related Documentation TM-ENDVRP60 EPSON Endeavor P60 Service Manual EPSON Endeavor P60 Parts Price List PL-ENDVRP60 EPSON Endeavor P60 User’s Guide 400304600 3/94 EPSON Endeavor P60 - 11...

Table of Contents