Standard Flush Door And Screen - Regency P33CE-NG Owners & Installation Manual

INSTALLATION
6) Place the bottom left front edge of Log 251
against the left edge of the burner tray and
rest the log on the cutout on Log 253.
250
251
7) Position Log 252 across the cutouts in Logs
254 and 253. The notch in the bottom right
end fi tting against the 5th grate tab.
254
5th Grate Tab
251
254
36
8) Pull off ember size pieces of rock wool and
gently place them on the front of the burner
tray in the places shown in the photo below.
Do not compress the rock wool, leave it
250
loose.
Separate platinum embers and place them
254
on the front of the burner on and around the
rock wool.
Place rock wool in these 2 locations
9) Test fi re to ensure proper light off (make
sure fl ame fl ows smoothly from one end of
254
burner to the other). If there is any fl ame
hesitation, check that area for any blockage
of the burner ports.
Cutout
STANDARD FLUSH DOOR AND
Both the standard fl ush door and glass screen
guard come with a black frame. To install the glass
screen guard simply hook the over top of the fl ush
glass door see Diagram 1. Install both screen and
glass door by hooking the top door fl ange onto the
top of the unit and swing the door towards the unit,
Diagram 2. Be careful that the glass gasket does not
roll up; there must be a gap between the gasket and
the door lip to ensure that the door sits securely on
the unit. See Diagram 3.
Screen Door
250
on the burner tray.
SCREEN
Glass Door
Diagram 1
Diagram 2
Diagram 3
Use the hook to pull the spring out until you can
put the hook into the slot on the bottom door
bracket. Repeat for 2nd spring. See diagram 3.
Diagram 4
To remove the fl ush door, reverse the above
steps.
P33CE Direct Vent Gas Fireplace