Table of Contents
Advertisement
INSTALLATION
STANDARD
FLUSH DOOR
The standard flush door comes with a black
frame. To install the frame, simply hook the top
door flange onto the top of the unit and swing
the door towards the unit, diagram 1.
Diagram 1
Be careful that the glass gasket does not roll up;
there must be a gap between the gasket and the
door lip to ensure that the door sits securely on
the unit. Diagram 2.
Diagram 2
Use the hook to pull the spring out until you can
put the hook into the slot on the bottom door
bracket. Repeat for 2nd and 3rd spring. See
diagram 3.
Diagram 3
NOTE: Springs must always be OVER
not under the gas line.
To remove the flush door, reverse the above
steps.
28
FLUSH LOUVERS
1) Install the top louver by sliding the two
bracket clips into the brackets located un-
derneath the top of the firebox.
2) Install the bottom louver by folding the lou-
ver down and then sliding the Bottom Lou-
ver bracket down onto the 2 pins on the
base of the unit (diagram 1). Secure with 1
screw as per diagram 2.
Diagram 1
Diagram 2
Note: Top and
bottom louvers
are different.
3) Open the bottom louver. Pull the Burner ON/
OFF control box from inside the bottom of
the fireplace. Using the 2 screws on the
louver, secure the control box in place.
Burner ON/OFF
Screws on
control box
louver bracket
Burner ON/OFF control box attached to
bottom flush louver.
Optional Flush Trim
Attach the round magnets to the back of the top
trim piece and to the bottom trim piece, then
attach trim to the top and bottom of Flush door.
Regency P48-1 Zero Clearance Direct Vent Gas Fireplace
Advertisement
Table of Contents
