Understanding Default Values And Logins - Ubee DVW326 User Manual

Ubee Interactive
 DTMF Tone Detection, T.38 FAX Relay (G.711), Echo Cancellation (G.168) /
Silence Suppression, Voice Active Detection and Comfort Noise Generation
 G.722 codec, WB SLIC
Device Management
 Supports IEEE 802.11e Wi-Fi Multimedia (WMM) and UAPSD (power savings)
 DOCSIS, Web-Based, and XML Configuration
 Telnet/SSH remote management
 Firmware upgrade via TFTP
 Configuration backup and restore
 SNMP support
 TR-069 capable
Physical and Environmental
 Dimensions: 63.4mm, 2.4" (W) x 233mm, 9.125" (H) x 225mm, 8.8" (D)
 Weight: 923g (2 lbs.) (Contains internal PSU)
 Input: 100-120VAC, 50-60Hz
 Output: 12V 2.17A
 Operating Temperature: 0°C ~ 40°C (32°F ~ 104°F)
 Humidity: 5~90% (non-condensing)
1.7

Understanding Default Values and Logins

The DVW326 is pre-configured with the default parameters for Cox Communications.
Some regions may change default values using the cable modem or XML configuration
file. Check with your provisioning team to determine the default values for your region.
Local Port Address: 192.168.100.1
Web Interface: http://192.168.100.1
Operation Mode: NAT Mode
Subnet Mask: 255.255.255.0
Wireless Defaults:
 Primary SSID (subscriber-managed) = "DVW326" plus a period, plus the last 6
characters of the Wi-Fi MAC address plus "-2.4G".
 Example for modem with WLAN MAC address F4:B7:E2:E5:C6:1A
 If the subscriber changes the SSID, the device does not revert to this default
 The Wi-Fi MAC address can be found at the top of the Wireless Primary
 Encryption Method = WPA2-PSK with TKIP+AES encryption
Ubee DVW326 Advanced Wireless Voice Gateway Subscriber User Guide • March 2014
SSID: DVW326.E5C61A-2.4G
SSID when the device is reset, except when a manual factory reset is
performed through the Web UI.
Network screen. Refer to Using the Primary Network Option on page

Understanding Default Values and Logins

71.
9